#Arduino car battery monitor full#
#Arduino car battery monitor portable#

This cookie is set by GDPR Cookie Consent plugin. The cookie is set by GDPR cookie consent to record the user consent for the cookies in the category 'Functional'.

The cookie is used to store the user consent for the cookies in the category 'Analytics'. These cookies ensure basic functionalities and security features of the website, anonymously. Necessary cookies are absolutely essential for the website to function properly.

#Arduino car battery monitor portable#

Now my ProtoStack Board is all ready for a future portable battery powered electronics project. This was a fun project to get myself familiar with the Arduino Analog pins. Here is a link to the spreadsheet: … I used to calculate the values for the custom characters.

#Arduino car battery monitor full#

I used the Parallax 16×2 LCD commands to create the custom characters for the “EH” and Full & Empty Battery Bar Segments. With these mods I was able to go down to 5.30V input voltage before the LCD stopped functioning. The L4941 has a drop out voltage of less than 0.45V when sourcing 1Amp. So I replaced the 1N4004 diode with a schottky diode that has a much lower 0.2V forward voltage and used a L4941 5V linear regulator to replace the 7805. These components require that the input voltage be greater than 7.8V in order to create the 5V rail properly. The ProtoStack board has a 1N4004 reverse polarity protection diode and a 7805 Linear Regulator to generate its 5V rail.

One issue I ran into was the 9V battery can go down as low as 5.71V before it is completely dead. I tied the input voltage through a resistor divider (220K Ohm series and 100K Ohm shunt) to the A0 pin on the micro.

With the plotted excel data: … from the discharge monitor I created a look-up table in software to approximate the battery life:īattery Voltage, Hours Life Left, Displayed Battery Barsħ.45V > Batt Batt Batt Batt Batt Batt Batt Batt <= 6.30V 0.5hrs, 1 Since we discharged the battery through a load that is similar to the ProtoStack board with LCD, the ESR of the battery has automatically been accounted for in the voltage measurements. Since all batteries have an internal equivalent series resistance (ESR), it is important to take that into account when only using a battery’s voltage to monitor its state of charge. The 100mA constant load was chosen because my ProtoStack Arduino Clone: … with LCD draws about 92mA and I wanted to write a sketch to display a battery bar and the approximate hours battery life left. In my last blog post: … I took an Adruino Uno and a Protoshield and made a simple battery monitor, so I could measure the voltage of a discharging 9V battery when it was drained through a constant 100mA load.